Fisher-Price Power Wheels B7659 Owner's And Assembly Manual page 25

Problem
Vehicle runs in low speed, but
does not run in high speed
Please Note: The vehicle is
designed to operate in low
speed only in reverse .
When the foot pedal is pressed
only one rear wheel spins
Sometimes the vehicle doesn't
run, but other times it does
When the foot pedal is pressed,
the vehicle won't run without
a push
Loud clacking or grinding
noise from a motor-gearbox
Charger gets warm during use
Battery makes a sizzling or
gurgling noise when charging
If, after reviewing the Problems and Solutions Guide, the vehicle still fails to operate, please contact your nearest
authorized service center or contact Power Wheels
Hint! For faster service when calling Consumer Relations, completely charge the battery before calling and have
the following available by the phone:
• vehicle,
• vehicle model number (see sticker in battery compartment),
• vehicle production run number (see sticker in battery compartment).
Problems and Solutions Guide
Possible Cause
High speed lock-out not disconnected
Operation of vehicle in low speed
Loose wire or connector
Motor or electrical switch damage
Loose wire or connector
"Dead Spot" on motor
Broken gears
It is normal for some chargers to get
warm during use and is not reason
for concern.
It is normal for some battery to
make noise and swell slightly while
charging and is not reason for
concern.
® Consumer Relations toll-free at 1-800-348-0751.
The vehicle was pre-set to run only in low speed.
To allow the vehicle to run in low and high speed, you
must disconnect the High Speed Lock-Out. Follow the
instructions on page 22 to remove the High
Speed Lock-Out screw.
It is possible that only one rear wheel may spin when both
rear wheels are raised off the ground and the vehicle is in
low speed. This does not necessarily indicate a problem.
Check for proper operation of the drive system by raising
the rear wheels off the ground and pressing the foot pedal.
If only one rear wheel spins, carefully press your hand on
the spinning wheel to slow it down. The other rear wheel
should begin to spin. If the other rear wheel does not begin
to spin, there may be a problem with the vehicle. Contact
your local Power Wheels
diagnosis and repair.
Check all wires around the motors and all connectors to
make sure they are tight.
Contact your local Power Wheels
center for diagnosis and repair.
Check all wires around the motors and all connectors
to make sure they are tight.
Contact your local Power Wheels
center for diagnosis and repair.
Contact your local Power Wheels
center for diagnosis and repair.
No action required.
If your charger does not get warm during
use, it does not mean that it is not working properly.
No action required.
If your battery does not make noise or swell slightly
during charging, it does not mean that it is
not accepting the charge.
25
Solution
® authorized service center for
® authorized service
® authorized service
® authorized service