Table of Contents
Advertisement
O
PTIONAL ACCESSORIES
This section describes optional accessory equipment for your printer. The following
accessories are available:
>
duplex unit (to enable two-sided printing) (C9655n only)
>
additional RAM memory
>
hard disk drive (required for verified and spooled printing, direct printing of PDFs,
when collation errors appear, adding extra fonts) (C9655n and C9655dn only)
>
lockable second paper tray (to increase paper input capacity and keep your paper
secure)
>
standard second, third paper tray (to increase paper input capacity)
>
high capacity feeder (equivalent to three paper trays) (C9655n, C9655dn and C9655hdn only)
NOTE
1. Tray configurations are: Tray 1 only, Tray 1 + 2nd Tray, Tray 1 + 2nd
Tray + 3rd Tray, Tray 1 + HCF, Tray1 + 2nd Tray + HCF
2. The C9655hdtn already has a High Capacity Feeder installed and so can
only accommodate one additional tray (to give the maximum total of
five).
>
Finisher (for stapling printer output)
>
Printer cabinet
>
Punch unit (to extend Finisher functionality)
I
NSTALLING ACCESSORIES
Each accessory (apart from the Finisher) comes complete with its own documentation
which gives full instructions on installation. You are advised to follow these instructions
carefully.
After installation, print out a Menu Map (Configuration document) to check that the
installation has been successful.
NOTE
The finisher and punch unit must be installed by an authorised engineer.
For the following accessories, you have to make the appropriate setting in your printer
driver(s):
>
duplex unit
>
paper tray(s)
>
finisher
Refer to the Printing Guide for driver setting details.
Optional accessories > 42
Advertisement
Table of Contents
