Installing The Router On A Workbench; Installing The Router On A Wall - HP A-MSR900 Series Installation Manual

Installing the router on a workbench

To install the router on a workbench, as shown in
Make sure the workbench is clean, stable, and properly grounded.
1.
Place the router upside down on the workbench and attach the rubber feet to the four round holes
2.
in the chassis bottom.
Figure 14 Installing the router on a workbench

Installing the router on a wall

CAUTION:
When mounting the router on a wall, position the router so the network interfaces face down (toward
the floor), and the sides with ventilation openings are perpendicular to the ground, as shown in
15.
To mount the router on a wall, as shown in 4:
Mark the locations of the two mounting holes on the wall, 180 mm (7.09 in) apart. The holes must
1.
be level (on the same horizontal line.)
Drill two holes in the wall.
2.
Following the marks, drill the two holes at least 22 mm (0.87 in) deep. Verify that the holes are
3.
level.
Insert an anchor into each hole so it is flush with the wall surface.
4.
Drive a screw into each anchor, keeping the screw heads protruding at least 1.5 mm (0.06 in)
5.
from the wall.
Hang the router on the screws.
6.
Figure 14:
12
Figure