Getting Started; Installing Your Phone - Uniden Elite 9135 Owner's Manual

GETTING STARTED

Installing Your Phone

Charge the Battery
1. Unpack all handsets, battery packs, and battery covers.
If you need to remove a cover, press in on the notch
and slide the cover down and off.
2. Line up the battery connector with the jack inside the
handset; the connector only fits one way.
3. Push the connector in until it clicks into place; tug
gently on the wires to make sure the battery is securely connected.
4. Replace the battery cover and slide it into place.
5. Use an AC adapter to connect the power jack on the base to a regular
indoor (240V AC) power outlet. Connect any chargers the same way.
6. Place a handset in the base with the display facing forward. If the
display doesn't light up, reseat the handset or connect the base to
a different outlet. For 2 or more handsets, place each handset in a
charger.
Charge all handsets completely (about 15 hours) before using.
#
Connect the Telephone Cord
Use the telephone cord to connect the
standard telephone wall jack.
Test the Connection
1. Pick up the handset and press
tone, and the display shows Talk.
– If you don't hear a dial tone or the display says
connection between the base and the phone jack.
2. Make a quick test call. (Press
– If there's a lot of noise, check for interference (see page 25).
3. Test all handsets the same way. If you can't get a dial tone, move the
handset closer to the base.
Attaching the Belt Clip
Line up the holes on each side of the handset. Insert the belt clip into
the holes on each side of the handset. Press down until it clicks.
To remove the belt clip, pull either side of the belt clip to release the
tabs from the holes.
TEL LINE
. The handset sounds a dial
Home/FlasH
Check Tel Line,
to hang up.)
end
jack on the base to a
check the
3