Program Version Upgrading; How To Confirm The Program Version; How To Upgrade The Program - Casio EX-S1 Service Manual And Parts List

Introduction
Update the program using an SD card.
Note:
Make sure to use a fully charged battery.
MAIN PCB becomes unusable if power down or an error occurs during program transmission.

1. How to confirm the program version

The program version can be confirmed in the test menu (refer to the previous page).
Turn the power on while pressing MENU button.
The following program version also can be found.
Check the LCD display.
(Example)
VER 1.00
2. How to update the firmware
1. Prepare the memory card which contains the software for upgrading firmware in the root directory.
EX-S1: ex-s1.bin
EX-M1: ex-m1.bin
2. Insert the above memory card into the camera, and set a fully charged battery in the camera.
3. While pressing MENU, press power switch.
Keep pressing MENU until "PROGRAM UPDATE" appears in the camera LCD.
The following appears.
The version for the firmware update software in the memory card appears at the bottom.
PROGRAM UPDATE
YES
NO
NEW VERSION IS
VER 1.00
4. Align the white cursor to "Yes" by the cross keys of
"NOW LOADING" appears in the LCD and the update starts.
5. "COMPLETE" appears after the update finishes.
6. Remove the memory card after turning the power off once.Turn the power back on again while pressing
MENU, and check the version.
VER 1.00

PROGRAM VERSION UPGRADING

(As of May 28. 2002)
and , and press SET.
VER1.00 appears this time.
— 5 —