Program Version Upgrading; How To Confirm The Program Version; How To Update The Firmware - Casio QV-R40 Service Manual & Parts List

Introduction
Update the program using an SD card.
Note: Make sure to use a fully charged battery.
MAIN PCB becomes unusable if power down or an error occurs during program transmission.

1. How to confirm the program version

The program version can be confirmed in the test menu (refer to the previous page).
Turn the power on while pressing MENU button.
The following program version can be found.
Check the LCD display.

2. How to update the firmware

1. Prepare the memory card which contains the software for upgrading QV-R40 firmware in the root directory.
firmware: QV-40.bin
The firmware is included in the service CD-ROM.
The location is as follows: QV/Soft/Adj-soft/Qvr40/FirmUP
2. Insert the above memory card in the camera and then set a fully charged battery in the camera.
3. While pressing MENU, press power switch. Keep pressing MENU until "PROGRAM UPDATE" appears in
the camera LCD.
• The following appears.
• The version for the firmware update software in the memory card appears at the bottom.
PROGRAM UPDATE
YES
NO
NEW VERSION IS
Note: This does not appear when the battery is low.
Make sure to charge the battery fully.
4. Align the white cursor to "YES" by the cross key of G and H, and press SET of the center of the cross key.
• "NOW LOADING" appears in the LCD and the update starts.
5. "COMPLETE" appears after the update finishes.
6. Remove the memory card after turning the power off once. Turn the power back on again while pressing
MENU, and check the version.
VER 1.00
(As of August. 2003)
7. If the version is correct, turn the power off.
8. Finally, check the operation by recording, playing back and deleting an image.

PROGRAM VERSION UPGRADING

— 6 —
(Example)
VER 1.00
(As of August. 2003)