Unpacking And Mounting The Switch; Unpacking The Switch; Prepare Rack; Remove Cover - Fortinet FortiSwitch-1000 Install Manual

Table of Contents

4 Unpacking and Mounting the Switch

NOTE: Prior to touching or handling the switch or any of its components, ensure that the

equipment is protected against all forms of electrostatic discharge (ESD). Personnel must ground

themselves before handling the switch or its components, and Fortinet recommends that all cards

should be handled using anti-static bags.

The packing crate in which the FortiSwitch-1000 is shipped is the safest place to store the switch

while preparing for installation. Ensure that chassis supports or shelving are properly installed

and secured before removing the switch from its crate; if third party or aftermarket shelving is

unavailable, Fortinet recommends use of the support brackets included in the shipping crate.

4.1.1.1 Support Brackets

Support brackets are shipped with the FortiSwitch-1000 to facilitate the mounting of the switch,

packed in the gap above the crate base (see below). They are designed to support the weight of

the chassis during mounting, and are attached at the front and rear of the shelving space (not on

the sides).

The crate cover is held in place by four hinged clasps; unfasten them by turning the handle

counterclockwise to disengage the clasp, then pulling the clasp away from the crate cover. Once

the clasps are unfastened, lift the cover straight up until it is clear of the chassis and set it aside.

Fortinet strongly recommends using a mechanical lift to install the switch in the rack. Before a lift

can be used, though, the switch must be manually lifted to free it from the crate base. Lift the

– 17 –

Table of Contents

Show Quick Links

Table of Contents