Handset Mount; Model; Color - Brother FAX1170 Service Manual

1.14 Handset Mount (for models except the FAX1010)
Side Cover (for the FAX1010)
(1) Disconnect the hook switch harness* from the main PCB.
(2) Remove the two screws from the handset mount* or the side cover**.
(3) Twist the handset mount* or the side cover** so that it tilts over to the left and its upper
end works out of the bosses provided on the side cover L.
(FAX1010)
Side
cover**
Thick portions "T" whose outer face
should be flush with the outer face of
the side cover L.
(4) To disassemble the handset mount* for models except the FAX1010, unhook the two
latches with a flat screwdriver.
Hook switch PCB
Hook switch harness
Lower mount
Reassembling Notes
• When assembling upper and lower mounts, route the hook switch harness underneath
the hook switch PCB and through the cutout as shown above. Take care not to pinch the
harness between the upper and lower mounts.
• The front and rear upper edges "T" of the handset mount are thick. Be sure to make their
outer face flush with the outer face of the side cover L.
(Models except the
FAX1010)

Handset mount*

Handset mount*
Upper mount
Latch
Side cover L
Latch
Routing of the hook
switch harness
Underneath the
hook switch
PCB
IV – 26
* For models except the
FAX1010
** For the FAX1010
Through the cutout