Table of Contents
Advertisement
Channel Menu
Channel Menu
Figure 7
Settings for the Channel
Number Shown
Figure 7. The Channel menu is divided into three sections.
Prefer Digital
When a memorized channel number is available in both
analog and digital formats, check the Prefer Digital box to
display digital channels and hide analog channels when
using CH
. Remove the check mark to show both
analog and digital choices.
Channel
You can select the channel number affected by this menu
in any of three ways:
•
Press ADJUST
numbers one at a time, including all memorized and
non-memorized channels. If you also wish to tune to
the channel, highlight the channel number and press
ENTER.
•
Press CH
memory. If you also wish to tune to the channel, high-
light the channel number and press ENTER.
•
Enter the number directly and press ENTER. Note
that with this method, you must press ENTER for the
screen to display settings for the selected channel.
Channel numbers can be one part, analog or digital (up to
the number 16383), or two part for digital channels. For
a two-part digital channel, press SUB/CANCEL on the
remote to enter a separator after the first, second, or third
number, depending on the broadcaster's channel informa-
tion.
Downloaded from
www.Manualslib.com
Signal-Strength
SuperQuickView
Memory Banks
to move through channel
to select from channels already in
manuals search engine
Chapter 4. TV Menu Operations
For digital channels, when the broadcaster has sent a
virtual channel number, the virtual channel number is
shown in the text box and the original digital channel
is shown below on screen as a reference. One original
Indicator
channel number can be associated with several different
virtual channels.
Memory
After the available channels have been memorized with
Memorize Channels on the Setup menu, weaker chan-
nels can be added or unwanted channels can be deleted.
Press CH
nels in memory. Press ADJUST
Deleted for the channel shown in the Channel number box.
Name
Analog channels shown on ANT 1 can be named (up to
four characters). After you enter a name, it will appear on
the TV screen, next to the channel number.
1.
Press ADJUST
2. Press ENTER to set the letter and move to the next
letter position.
3. Press CANCEL to move back one position.
Digital channels are named automatically if the broad-
caster sends the information.
SQV (SuperQuickView™)
Figure 17
SQV (SuperQuickView™) allows you to put together lists
of your favorite channels available on the antenna input.
You can store channels in any of the nine different SQV
memory banks. You can also store the same channel in
multiple memory banks. Once you have added a channel
to an SQV memory, "SQV" and the memory bank number
appear under the tuned channel number on the TV screen.
Managing SQV Memory Banks through the Menu
Adding SQV Channels Using the Menu
1.
Select the channel using the "Channel" option box or
press CH
2. Highlight the desired bank (SQV1-SQV9).
3. Press ENTER to check mark the selected SQV
memory bank.
4. Repeat for additional channels or banks.
on the remote control to see the chan-
to select Added or
to select each letter.
.
45
Advertisement
Table of Contents
