Pioneer DVR-210-S Manual page 60

Table 2: Description of VR-recording-related errors
Error
Message
Non Err ∗
DRAM NG
SRAM NG
CPRM IC NG
Drive Destroy
MKB REVOKED
WM Cracked
VBR-SRAM NG
BK BATT Down
BK FSYS Dirty
Stream NG
Stm Start NG
AVEnc Hang
No SysHdr IN
Strm Start NG
IN Encode ∗
EncModul Hang
Ourob Strm NG
WaterMark Det
BUF Overflow
Drive Hang
Write Err
Read Err
Drv Hard Err
Mech No Res
Drv TimeOut
NWA Exhaust
MKB Invalid
Drv Err
DISC Full
No More Info ∗
No Perm ∗
Limit Over ∗
Rec Pause ∗
No Video ∗
Relocation Do
Invalid Param ∗
Protect Src ∗
Now Busy ∗
Invalid Disc ∗
Invalid UDF ∗
Invalid VMG ∗
Notes;
• Any error message marked with ∗ is displayed "RecErr : ---------"
on Subscreen 1 of the fourth screen.
• : Indicates an error of the MPEG encoder
: Indicates an error of the drive system
• In a case of an error in the drive system, scratches or dirt on a disc,
or a problem of the drive itself (dirty pickup) may be suspected.
59.
Description
Normal
Abnormality in access to the work DRAM
Abnormality in access to the backup work SRAM
Inappropriate CPRM IC
The drive has crashed.
Error in gaining data
WM cracked
Abnormality in VBR SRAM
Backup RAM data has been erased.
Backup RAM data has been written on the file
system.
Inappropriate input stream data
Failure to start encoding (reasons not clear)
Inappropriate MPEG encoder
System packet is not input periodically.
Timeout waiting for system packet input at the
beginning
Changes cannot be made in the process of
encoding
Encoder routine is hung up.
Inappropriate stream data to the Ouroboros input NV Pck DMA Err
Watermark detected
Overflow of the stream buffer
The drive is hung up.
The drive failed to write and could not be
recovered.
Reading failed, ECC failed, etc.
Abnormality in the drive hardware or firmware
No response from the mechanical-control
computer
Timeout waiting for drive operation
NWA surpassed and impossible to use
MKB reading error
General error of the drive
No further data can be written because the disc is
full.
No more space in the internal work-management
area
No permission to write to the disc
Standard maximum limit exceeded
No operation permitted during recording pause
No video input (not locked)
VR-recording data was relocated.
Invalid parameter
Source to be recorded is copy-protected.
In the process of the emergency processing
The disc cannot be recognized.
Invalid UDF content
Invalid VMG content
Error
Message
Invalid TMVMG Invalid TMP_VMGI content
Impossible to modify because of nonmatching
Unmatch Stamp ∗
time stamps
Virgin DISC Blank disc
Fail Repair Repair failed
Because some data are invalid, data cannot be
ReadOnly DISC ∗
written.
Rzn Rsv NG R-zone reserve failed.
Rzn Cls NG R-zone Closure failed.
Rzn Rpr NG R-zone repair failed.
Bdr Opn Opening of border failed.
Bdr Cls Closing of border failed.
Format NG Formatting failed.
OPC NG OPC failed.
PCA Full PCA has been used up.
RMA Full RMA has been used up.
SW Vrec mode ∗
Switching to video recording routine is required.
SW Vpb mode ∗
Switching to video playback routine is required.
NV Pck MK Err Error in creating NAVI pack
Inappropriate NAVI pack DMA
Cell Close NG Cell closure failed.
Something ∗
Undetermined error
Status NG ∗
Abnormality in change of statuses
Irr Action ∗
Incorrect action
Abort ∗
Cancellation
Repair Exec Repairing has been executed.
Format Exec Formatting has been executed.
BUG Some bugs
BusReset Done Bus Reset has been executed.
Task No Activ Task has not been activated.
Mem get NG Video mode memory has not been ensured.
V Rsv RzoneNG Video mode reserve R-zone failed.
Video Mode Tracon transfer has not been
Tracon Tm NG
completed.
DRAM CLR Err Video Mode DRAM (Stream Buffer) clear failure
VTSI_B Wr Err Video Mode VTSI BUP write error
VTSI Wr Err Video Mode write error
TMP-VMG WrErr Video Mode TMP VMGI write error
CLS Rzon Fail Video Mode Closure R-zone failure
V Categ ID NG Inappropriate Category ID
V Cate Inf NG Inappropriate Category information
V Ext TY NG Typing error
V Ext MAX Ovr Count MAX exceeded
V ExtfToo Big The extension file is too large.
HDD Destroy HDD not recognized on the bus.
Abbreviations:
ECC = 4 byte Code for Error Correction
UDF = Universal Disc Format
PCA = Power Calibration Area
OPC = Optical Power Control
NWA = Next Writable Address
Description
VMG = Video Manager
RMA = Recording Management Area
MKB = Media Key Block
TMP_VMGI = Temporary Video Manager
Information
Border = from Lead-in to Lead-out