MULTIQUIP FCG1 SERIES Operating & Parts Manual page 26

7. If the engine has started, slowly return the choke lever
(Figure 20) to the "OPEN" position. If the engine has not
started repeat steps 1 through 5.
8. Before the saw is placed into operation, run the engine for
several minutes. Check for fuel leaks, and noises that would
associate with a loose guards and/or covers.
9. Rotate the throttle lever (Figure 21) toward full throttle.
WARNING WARNING WARNING
WARNING WARNING
ALWAYS cut with the saw at FULL THROTTLE. Attempting
to cut with the saw at less than full throttle could cause the
blade to bind or stop abruptly in the slab resulting in serious
injury to the operator or others in the area.
WARNING WARNING WARNING
WARNING WARNING
ALWAYS keep clear of rotating or moving parts while
operating this equipment.
10. To begin sawing, lower the rotating blade allowing it to cut to
the preset depth.
11. When blade has reached full cutting depth, slowly walk
behind the saw at a rate that will allow the engine to operate
without losing optimum RPM.
CAUTION CAUTION CAUTION
CAUTION CAUTION
DO NOT try to cut faster than the blade will allow. Cutting
too fast will cause the blade to rise up out of the cut.
Improper cutting rate can decrease the life of the engine
and blades.
12. When the end of the cut has been reached, raise the blade
out of the cut by pulling back on the handlebars (using a
downward pressure) until the raise/lower rod drops into its
slot with the blade in the raised position.
13. If cutting is complete, shut the saw down using the following
"Shutdown Procedures".
PAGE 26 — FCG1 CONCRETE SAW— OPERATION & PARTS MANUAL — REV. #2 (03/10/04)
FCG1 CONCRETE SAW — OPERATION
Stopping the Engine
Stopping the engine under normal conditions:
1. Place the engine throttle lever (Figure 23) in the SLOW
position, and listen for the engine speed to decrease. Allow
engine to run for 2 or 3 minutes for proper cooldown.
Figure 23. Throttle Lever
2. Turn the engine Shutdown switch (next to the handle lock)
(Figure 24) to the "OFF" position. Shutting the engine off
using this switch confirms that is is functioning properly.
Figure 24. Engine Shutdown Switch
3. Turn the engine ON/OFF switch (Figure 25) to the "OFF"
position.
Figure 25. Engine ON/Off Switch ( engine)
4. Place the fuel valve lever (Figure 26) to the OFF position.
Figure 26. Fuel Valve Lever (Off Position)