MULTIQUIP FCG1 SERIES Operating & Parts Manual page 25

Concrete saw

Hide thumbs Also See for FCG1 SERIES:

Table of Contents

3. Place the engine Shutdown switch (next to the handle

lock), and the engine ON/OFF switch on the engine to the

"ON" position. Shutting the engine off using this switch

confirms that is is functioning properly.

NOTE

4. Place the Choke Lever (Figure 20) in the " CLOSED "

position.

Figure 20. Choke Lever

CAUTION

The engine speed has been set at the

factory. Changing the governor speed

could damage the blade and/or the saw.

5. Rotate the throttle lever (Figure 21) halfway between fast

and slow for starting. All sawing is done at full throttle . The

engine governor speed is factory set to ensure optimum

blade operating speeds.

FCG1 CONCRETE SAW — OPERATION & PARTS MANUAL — REV. #2 (03/10/04) — PAGE 25

Always use the Engine Shutdown

Safety Switch located next to the

handle lock to shut down the engine.

Shutting the engine off using this

switch confirms that is is functioning

properly.

FCG1 CONCRETE SAW — OPERATION

Figure 21. Throttle Lever

6. Grasp the starter grip (Figure 22) and slowly pull it out. The

resistance becomes the hardest at a certain position, corre-

sponding to the compression point. Pull the starter grip briskly

and smoothly for starting.

CAUTION

DO NOT pull the starter rope all the way to the end. DO

NOT release the starter rope after pulling. Allow it to

rewind as soon as possible.

Figure 22. Starter Grip

Table of Contents

Troubleshooting