Ring Volume; Ring Tone; Optional Headset Adapter - Siemens ROLMphone 120 Series User Manual

Sound
Very short tone after
dialing
Wavering (error) tone

Ring Volume

Use the slide control to adjust the ringing volume of your phone. The
slide control is located underneath the RP240, RP240E, and RP400
and either underneath or on the side of the RP120 and RP240 Basic.
The volume remains at the level you set it until you adjust it again.

Ring Tone

When first installed, your phone will have a predetermined ring. You
can change your phone's ring tone to any one of eight tones. For
information about how to do this, see "Changing Your Ring Tone" on
page 2-23.

Optional Headset Adapter

Your phone can be ordered with a headset adapter that provides for two
headsets — one for a user and one for a supervisor. The adapter's two
pairs of jacks appear on the left side of the RP400 and on the back of
the RP120, RP240, and RP240E. (See Figure 1-5.) The PJ327 type
connector fits into a pair of jacks. When the headset is plugged in, the
speakerphone or speaker does not function.
Note: The ROLMphone 400 HR lets you attach a recorder. In
addition to recording the conversation of a connected call, the
recorder may also record user's comments between calls via
the handset or headset.
Meaning
You have been routed to the
next outgoing trunk or to a
more expensive route.
Invalid feature request
Introduction 1-17