Dell Precision Workstation 470 User Manual page 94

Removing and Replacing Parts: Dell Precision Workstation 470 and 670 Computers User's Guide
1 tabs (2)
2 CD/DVD drive
Installing a CD/DVD Drive
1. If you are installing a new drive, unpack the drive and prepare it for installation.
Check the documentation that accompanied the drive to verify that the drive is configured for your computer. If you are
installing an IDE drive, configure the drive for the cable select setting.
2. Connect the new drive to the set of rails that are attached to the inside of the computer cover. If a set of rails is not
attached inside the cover,
3. If you are installing a replacement drive and the new drive does not have the bracket rails attached, remove the rails
from the old drive by removing the two screws that secure each rail to the drive. Attach the bracket to the new drive
by aligning the screw holes on the drive with the screw holes on the bracket rails and then inserting and tightening all
four screws (two screws on each rail).
file:///T|/htdocs/systems/ws670/EN/ug_en/before.htm[3/20/2013 9:31:52 AM]
contact Dell for the number to call for assistance.