Initial Settings - JVC HD-ILA HD-65DS8DDU Instructions Manual

Initial settings

Register digital / analogue channels on TV. These channels can be edited later.
(In this manual, digital terrestrial broadcasting is indicated as digital channels,
analogue terrestrial broadcasting and analogue cable TV as analogue channels.)
When turning on the TV, it takes about
1 minute to project the picture to its full
brightness.
When turning off the TV, it takes about 5
seconds to make the screen dark. After
that, cooling is performed for about 1
minute.
"About the LAMP indicator" (P. 6)
To the previous screen
Exit
If the "JVC" logo does not appear or if you wish to
make changes later
Digital channel settings : "DTV Configuration" (P. 25)
"DTV Installation" (P. 27)
Analogue channel settings : "Set Up" (P. 22)
What is "T-V LINK"?
Connecting the TV to a "T-V LINK"
compatible device allows :
Analogue channels to be instantly
registered on the device.
The "DIRECT REC" function to be
used.
"Technical information" (P. 33)
"T-V LINK" variations
"T-V LINK" (JVC) "Q-LINK" (Panasonic)
"Megalogic" (Grundig) "Data Logic" (Metz)
"SMARTLINK" (Sony) "Easy Link" (Philips)
10
TV/DTV
BACK
Begin
1
Shown only when powering on for the first time.
The power button on the unit can also be used.
Set digital channels
2
1
Select a language
First Time Installation > Language Setting
Step 1: Please choose language
Language
Castellano
Català
Deutsch
English
Français
Suomi
Svenska
2
Select the country of installation
First Time Installation > Country Setting
Step 2: Please choose country
Country
Finland
France
Germany
Spain
Sweden
3
Set the aerial power supply
Stop Channel
Antenna Power Mode
On Start Scan Off
4
Scan digital channels
First Time Installation > Service Scan
Step 3: Please press OK
Service Scan Automatic
_ _
Start Channel
Stop Channel _ _
Mode Add
Start Scan
5
Register digital channels
_ _
Stop Channel
Teema
Teema Add
Scan completed! Store services? Mode
Teema
Yes Start Scan No
If digital channels are not found, the following message will appear.
No services found!
OK
After completing following steps, read "When the TV cannot find the digital
channels" (P. 11) and try scanning digital channels again
The remote control
doesn't work
Confirm the mode is set to
"TV".
Language for on-screen
1 select
displays when watching digital
channel including the DTV
menu.
2 set
Receivable digital channels will
1 select
differ depending on the country
setting.
The illustrations are for Finland
2 set
Only when using an aerial which
needs external power, select "On".
1 select
"Power supply for the indoor
2 set
aerial" (P. 33)
First Time Installation > Service Scan
Step 3: Please press OK
Service Scan Automatic
YLE TV1 Start Channel _ _
YLE TV2
_ _
Stop Channel
YLE FST
Mode Add
Start Scan
UHF33 : 3 Services found
!
(Next page)