Dell Precision WorkStation 610 User Manual page 63

Total
Desired
Memory
64 MB
64 MB
96 MB
128 MB
192 MB
256 MB
384 MB
512 MB
Table 9-2. Sample Registered SDRAM DIMM Configuration Options
Total
Desired
Memory
512 MB
768 MB
1024 MB
2048 MB
Follow this procedure to perform a memory upgrade:
1. Remove the computer cover according to the instructions in
CAUTION:
2. To access the DIMM sockets on the system board, rotate the power supply as described in
Away From the System
3. Determine the DIMM sockets in which you will install DIMMs or replace existing DIMMs.
4. Install or replace DIMMs as necessary to reach the desired memory total.
Follow the instructions in
5. Rotate the power supply back into position, making sure the securing tab snaps into place.
6. Replace the computer cover, and reconnect your computer and peripherals to their power sources and turn them on.
NOTE: After you remove and replace the cover, the chassis intrusion detector will cause the following message to
be displayed at the next system start-up:
ALERT! Cover was previously removed.
The system detects that the new memory does not match the existing system configuration information and generates the
following message:
The amount of system memory has changed.
Strike the F1 key to continue, F2 to run the setup utility
7. Press <F2> to enter the System Setup program, and check the value for System Memory in the lower-right corner of Page
1.
A
32 MB
64 MB
32 MB
32 MB
64 MB
128 MB
64 MB
128 MB
A
256 MB
256 MB
256 MB
512 MB
See "Protecting Against Electrostatic
Board".
"Installing a DIMM" or
DIMM Socket
B
32 MB
32 MB
32 MB
64 MB
128 MB
64 MB
128 MB
DIMM Socket
B
256 MB
256 MB
256 MB
512 MB
"Removing the Computer
Discharge".
"Removing a DIMM" as appropriate, found later in this section.
C
32 MB
32 MB
32 MB
128 MB
128 MB
C
256 MB
256 MB
512 MB
Cover".
"Rotating the Power Supply
D
32 MB
32 MB
128 MB
128 MB
D
256 MB
512 MB