General Information; Installation; Door Removal - Viking Professional Freestanding Dual Fuel Ranges Installation Manual

Professional freestanding dual fuel ranges
Hide thumbs Also See for Professional Freestanding Dual Fuel Ranges:
Table of Contents

Advertisement

General Information

READ AND FOLLOW ALL WARNING
Moving, Handling, and Unpacking
AND CAUTION INFORMATION WHEN
Remove and discard all packing materials,
INSTALLING THIS APPLIANCE.
including cardboard and tape on the outside
and inside of the range.
• All openings in the wall behind the
appliance and in the floor under the
Remove the burner grates and styrofoam
appliance must be sealed.
off the top cooking surface. Be sure to
remove the burner caps packaged in
• Do not obstruct the flow of combustion and
styrofoam below the burner grates.
ventilation air.
Do not discard the anti-tip metal
CAUTION
bracket supplied with the range.
This is the anti-tip device and must
Avoid any damage to oven vents. The vents
be installed with the unit. Refer to
need to be unobstructed and open to provide
"Anti-tip Device Installation"
proper airflow for optimal oven performance.
section.
CAUTION
Some stainless steel parts may have a plastic
protective wrap which must be peeled off.
The cooling fan should be operating when
The interior should be washed thoroughly
the unit is in operation. If you notice the
with hot, soapy water to remove film
cooling fan is not operating or you observe
residues and any dust or debris before being
unusual or excessive noise coming from the
cooling fan, contact a Viking Authorized
used, then rinsed and wiped dry. Solutions
Service Center before continuing operation.
stronger than soap and water are rarely
Failure to do so can result in damage to the
needed.
oven or surrounding cabinets.
14

Installation

NOTICE
DO NOT use the handle or oven door to
lift the oven. Remove door before
installation to ensure that it is not used to
lift the unit. DO NOT lift or carry the door
by the handle.
Removing the door must be done by your
dealer, a qualified licensed plumber, or
certified gas installer.

Door Removal

1
Open door completely. Place pins, supplied with unit, in
Remove hinge trim screws. Take off hinge trim. Identify
pin hole. For personal safety, ONLY use pins
supplied with the unit.
3
Close until pins stop door.
15
2
right and left hinge for future re-installation.
4
Lift door up and out.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vdsc series

Table of Contents