Compatible Pictures; Signal Mode; Colour Hue Setting; Color Temperature - Panasonic PT-LC76U Operating Instructions Manual

BRIGHT
This adjusts the darker areas (black
areas) in the picture. Press the H
button if dark areas are too solid (for
example, if hair is difficult to see), and
press the I button if black areas are
too light (grey rather than black).
COLOR
(S-VIDEO/VIDEO/YP P only)
B R
Press the H button to make the
colour more vivid in tone, and press
the I button to make the colour
more pastel in tone.
TINT
(NTSC/NTSC 4.43/YP P only)
B R
This adjusts the flesh tones in the
picture. Press the H button to make
flesh tones more greenish, and
press the I button to make the
flesh tones more reddish.
SHARPNESS
Press the H button to make the
picture details sharper, and press
the I button to make the picture
details softer.

Colour Hue Setting

(color temperature)

C O L O R T E M P . S T A N D A R D
[
H I G H
[
L O W
This is used to adjust the white
areas of the picture if they appear
bluish or reddish.
WHITE BALANCE R/G/B
(RGB only)
This is used to adjust the white
areas of the picture if they appear
colourised. Press the I button to
make the selected colour lighter.
36-E
NGLISH
Press the H button to make the
selected colour stronger.
TV SYSTEM
(S-VIDEO/VIDEO only)
T V S Y S T E M A U T O 1
[
A U T O 2
[
N T S C
[
N T S C 4 . 4 3
[
P A L
[
P A L - M
[
P A L - N
[
S E C A M
AUTO1 The projector automatically
distinguishes between NTSC/NTSC
4.43/PAL/PAL60/SECAM signals.
AUTO2 The projector automatically
distinguishes between NTSC/PAL-
M/PAL-N signals.
NOTE:
B This should normally be set to
"AUTO1" or "AUTO2". If the
signal is of such poor quality
that the correct format cannot
be automatically distinguished,
change the setting manually to
the required TV system.

STILL MODE

S T I L L M O D E O F F
[
O N
To reduce flickering of still images
(vertical flicker), set "STILL MODE" to
"ON" by pressing the I or H buttons.
NOTE:
B Do not set "STILL MODE" to "ON"
when playing back moving images.

SIGNAL MODE

(RGB/YP P only)
B R
This displays the type of signal which is
currently being projected.
Refer to the table on page 56 for details on
each type of signal.
Projecting sRGB-compatible
pictures
sRGB is an international colour reproduction
standard (IEC61966-2-1) established by the
International Electrotechnical Commission
(IEC). If you would like the colours in sRGB-
compatible pictures to be reproduced more
faithfully, make the following settings.
# # Press the F F or G G button to select
"PICTURE MODE", and then use the I I
or H H button to select "NATURAL".
$ $ Press the STANDARD (STD) button on
the remote control unit.
% % Press the F F or G G button to select
"COLOR TEMP.", and then use the I I
or H H button to select "STANDARD".
NOTE:
B sRGB is only enabled when RGB
signals are being input (when LAMP
POWER has been set to "HIGH").
E -37
NGLISH