2-3. UPDATING MODEL INFORMATION
AFTER REPLACING THE FB1 BOARD
Complete the following steps to reset the model information to the
correct size after replacing the FB1 Board.
1. Access the Service Menu by pressing the following buttons on the
Remote Commander within a second:
Channel 5
DISPLAY
The service menu displays.
JUMP
2. Press the
button until the BEM micro service menu displays.
BEM
BOOT:
MAIN:
DATA:
3. Press 2 until the 0001 MODEL_INFO category displays.
BEM
0001
MODEL_INFO
0001
PANEL_SIZE
DIFF
4. Using the 3 or 6 on the remote commander to increase or decrease
the value, do one of the following:
If model size is 40"
If model size is 46"
5. To write into memory, press MUTING then 0 on the Remote
Commander.
8. To exit service mode, turn the power off.
KDL-40XBR4/40XBR5/46XBR4/46XBR5
Volume +
TV POWER .
SERVICE
0. 026W00AU
0. 050W00AU
0. 049A00LUW
SERVICE
0
1
Set to 0
Set to 1
KDL-40XBR4/40XBR5/46XBR4/46XBR5
23