Vise Operation; Fence Operation; Depth Stop; To Change Spacing Between The Fence And Vise - DeWalt D28710 Instruction Manual

Vise Operation (Fig. 4)
The vise (F) has a quick-travel feature. To release the vise when it is
clamped tightly, turn the crank (H) counterclockwise one or two times
to remove clamping pressure. Lift vise lever (I) up. Pull crank assembly
out as far as desired. Vise may be pushed forward into work without
cranking. Lower vise lever (I) then tighten vise (F) on work by using
crank (H).

Fence Operation

WARNING: Turn off and unplug the tool before making
any adjustments or removing or installing attachments or
accessories. Be sure the trigger switch is in the OFF position.
The fence (E) can be adjusted two ways: to change desired cutting
angle and to change spacing between the fence and vise.
TO CHANGE THE DESIRED CUTTING ANGLE (FIG. 5, 6)
Use the wrench provided to loosen (do not remove) the two fence
bolts (Q). Align the desired angle indicator line with the slot line (R) in
the base (D). Securely tighten both fence bolts before use.
G
FIG. 5
D
R
E
For more accurate square cuts, disconnect the power supply, loosen
the two fence bolts, push arm down until wheel extends into base.
Q
F
7 7
Place a square against the wheel and adjust fence against the square.
Securely tighten both fence bolts before use.
Q
FIG. 6
R
E
When making a miter cut, the vise (F) may not clamp securely,
depending on the thickness of the workpiece and the miter angle.
Other aids (such as spring, bar or C-clamps) will be necessary to
secure the workpiece to the fence when making these cuts.

TO CHANGE SPACING BETWEEN THE FENCE AND VISE

Using the wrench provided, loosen and remove the two fence bolts
(Q). Adjust the fence (E) to desired locations. Insert both fence bolts
in provided locations. Securely tighten both fence bolts before use.
Depth Stop (Fig. 1)
Depth stop is set at the factory for a new 14" (355 mm) wheel to
prevent wheel from cutting into the supporting surface. To allow more
depth of cut, use the 8 mm hex wrench (G) provided to loosen the
depth stop bolt (M) and raise bolt to desired height and then turn jam
nut (P) clockwise until seated firmly on the casting. Securely tighten
the depth stop bolt before use.
CAUTION: When changing to a new wheel, readjust depth stop to
original position to prevent cutting into supporting surface.
J