Viking Designer Series Installation Manual page 7

I I N N S S T T A A L L L L I I N N G G T T H H E E V V E E N N T T I I L L A A T T O O R R S S
V V I I V V 3 3 0 0 0 0 o o r r V V I I V V 6 6 0 0 0 0 - - I I n n t t e e r r i i o o r r - - P P o o w w e e r r V V e e n n t t i i l l a a t t o o r r K K i i t t ( ( 3 3 0 0 0 0 o o r r 6 6 0 0 0 0 C C F F M M ) )
(also see instructions supplied with ventilator kit)
1. Make sure barrel nuts and wing nut are engaged halfway onto
threaded stud.
2. Lift ventilator into canopy - may be easier to turn
ventilator side ways to lift into canopy then rotate
into mounting position.
3. Lift ventilator allowing barrel nuts to come
through large end of keyhole opening.
4. Slide ventilator to the right, engaging barrel
nuts into small end of keyhole openings and
engaging studs with wing nut in slot on right side
of ventilator. Make sure discharge openings
match.
5. Tighten barrel nuts and wing nut.
6. Plug the ventilator power cord into the receptacle
located on the topside of the light panel.
Remove rear filter support before installing
blower. After installation is complete,
reinstall the rear filter support.
V V I I V V 1 1 2 2 0 0 0 0 - - I I n n t t e e r r i i o o r r - - P P o o w w e e r r V V e e n n t t i i l l a a t t o o r r K K i i t t ( ( 1 1 2 2 0 0 0 0 C C F F M M ) )
(also see instructions supplied with ventilator kit)
1. Make sure barrel nuts and wing nut are engaged
halfway onto threaded stud.
2. Lift ventilator into canopy - may be easier to turn
ventilator side ways to lift into canopy then rotate into
mounting position.
3. Engage tab on ventilator with slot in rough-in plate
AND engage slot in ventilator with barrel nut on
threaded stud.
4. Push ventilator towards the back of hood to fully
engage.
5. Use a long, flat-head screwdriver to tighten the barrel
nut securely.
6. Plug the ventilator power cord into the receptacle
located on the topside of the light panel.
1200 CFM Blower
Remove rear filter support before
installing blower. After installation
is complete, reinstall the rear filter
support.
Rough-in
Plate
Barrel Nuts
9"
(22.9 cm)
Studs
Barrel Nut
7
Top of Hood
Studs
Wingnut
600 CFM Blower
Transition
Top of
Hood
Slot
Rough-in Plate