Range Hood Care; Cleaning - Whirlpool 36" (91.4 CM) ISLAND-MOUNT CANOPYRANGE HOOD Use & Care Manual

IMPORTANT: Clean the hood and grease filters frequently
according to the following instructions. Replace grease filters
before operating hood.
Exterior Surfaces:
To avoid damage to the exterior surface, do not use steel wool or
soap-filled scouring pads.
Always wipe dry to avoid water marks.
Cleaning Method:
Liquid detergent soap and water, or all-purpose cleanser
Wipe with damp soft cloth or nonabrasive sponge, then rinse
with clean water and wipe dry.
Metal Grease Filters
1. Open the stainless steel panel. Grasp panel at the left corners
and pull down to disengage the 2 catch pins from the spring
catches. The panel is attached at the right and will rotate
down.
2. Remove each filter by pulling the spring release handle and
then pulling down the filter.
A
A. Spring release handle
3. Wash metal filter as needed in dishwasher or hot detergent
solution.
4. Reinstall the filter by making sure the spring release handles
are toward the front. Insert aluminum filter into upper track.
5. Push in spring release handle.
6. Push up on metal filter and release handle to latch into place.

RANGE HOOD CARE

Cleaning

Non-Vented (recirculating) Installation Filters
The charcoal filter is not washable. It should last up to 6 months
with normal use. Replace with Charcoal Filter Kit Number
W10412939.
To replace charcoal filter:
1. Remove metal grease filter from range hood. See "Metal
2. Bend spring clips away from metal grease filter.
3. Place charcoal filter into top side of metal filter.
4. Bend spring clips back into place to secure the charcoal filter
5. Replace metal grease filter. See "Metal Grease Filters" in this
Replacing a LED Lamp
The LED lights are replaceable by a service technician only. See
"Assistance and Service" section for service contact information.
Grease Filters" in this section.
to the metal filter.
section.
13