Lenovo ThinkCentre 3656 Hardware Maintenance Manual page 140

10. Align the drive bay assembly studs with the two slots on each side of the
11. Slide the drive bay assembly towards the rear of the chassis until it snaps into
12. Reinstall the front bezel.
13. Go to "Completing the FRU replacement" on page 141.
134
Hardware Maintenance Manual
6. Install the new drive into the blue bracket, flex the bracket, and align the pins
1 through 4 on the bracket with the holes in the hard disk drive. Do not
touch the circuit board 5 on the bottom of the hard disk drive.
7. Connect the signal and power cables to the rear of the hard disk drive.
8. Position the hard disk drive and bracket so that it engages the retaining clips
in the bottom of the chassis when you slide the bracket to the right.
9. Slide the hard disk drive and bracket to the right until it snaps into position.
chassis and reconnect the diskette drive and optical drive cables (if
disconnected).
position.