Example
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
�
Permitted range is 0~9 and ".". If the wildcard "." is used,
the wildcard number in the abbreviated number must not be
less than the wildcard number in the destination mode phone
number.
�
It is only applied to ZXR10 GAR and ZXR10 ZSR.
This example describes how to abbreviate the phone number
0250001 into 0001.
ZXR10(config)#num-exp 0250001 0001
output gain
Use this command to configure the voice port output attenuation
value. Restore the default value with no command.
Voice port configuration
output gain <value>
no output gain
<value>
�
The modified voice port configuration will take effect in the next
dial-up.
�
It is only applied to ZXR10 GAR and ZXR10 ZSR.
This example describes how to configure the output attenuation
value 40 dB on port voice_3/1.
ZXR10(config)#voice-port voice_3/1
ZXR10(config-voice-port)#output attenuation 40
port
Use this command to associate a dial-peer of POTS type to a des-
ignated voice port. Cancel the association with no command.
Dial-up peer configuration
port <voice-port>
no port
<voice-port>
�
This command is only applied to the dial-peer in pots type.
�
The modified dial-peer configuration will take effect in the next
dial-up.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 VOIP Configuration
Voice output attenuation value, in the range
of -140~60, in unit of db, 0 dB by default
Specify the voice port
17