Comfort-Noise; Description - Zte ZXR10 Command Manual

Purpose
Command Modes
Syntax
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Syntax

Description

Instructions
Example
ZXR10(config)#dial-peer voice 100 voip
ZXR10(config-voip100)#codec g711alaw

comfort-noise

Use this command to enable the comfort noise configuration. Dis-
able the function with no command.
Voice port configuration

comfort-noise

no comfort-noise
the comfort noise configuration is enabled by default.
� When the relevant dial-peer is configured with the mute detec-
tion function, the proper background noise will be generated
through this command to fill in the silent gapping in the con-
versation. If the comfort noise is not generated, the silent
gapping in the conversation will discomfort the caller/callee.
� The modified voice port configuration will take effect in the next
dial-up.
� It is only applied to ZXR10 GAR and ZXR10 ZSR.
This example describes how to enable the comfort noise on port
voice_3/1.
ZXR10(config)#voice-port voice_3/1
ZXR10(config-voice-port)#comfort-noise

description

Use this command to configure the voice port descriptor. Delete
the descriptions with the no command.
Voice port configuration
description <string>
no description
<string>
It is only applied to ZXR10 GAR and ZXR10 ZSR.
This example describes how to configure the descriptor "zxr10
voice port" for port voice_3/1.
ZXR10(config)#voice-port voice_3/1
ZXR10(config-voice-port)#description zxr10 voice port
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 VOIP Configuration
Voice port descriptor, not more than 64
characters
9