Ip Nat Service; Ip Nat Slot-Number - Zte ZXR10 Command Manual

Syntax
Syntax
Description
Example
Purpose
Command Modes
Syntax
Syntax
Description
Example
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
ip nat pool <pool-name><start-address><end-address> prefix
-length <prefix-length>
no ip nat pool <pool-name>
<pool-name>
<start-address>
<end-address>
<prefix-length>
This example describes how to configure an address pool named
p1 from 170.1.1.1 to 170.1.1.78.
ZXR10(config)#ip nat pool p1 170.1.1.1 170.1.1.78
prefix-length 24

ip nat service

Use this command to configure ALG application of non-standard
interface. Delete the configuration with the no command.
Global configuration
ip nat service ftp port <port-number>
no ip nat service ftp port <port-number>
<port-number>
This example describes how to configure FTP ALG application on
port 21.
ZXR10(config)#ip nat service ftp port 21

ip nat slot-number

Use this command to configure slot number which enables NAT
service. Delete this configuration with the no command.
Global configuration
ip nat slot-number <slot-number>
no ip nat slot-number
<slot-number>
This command is only supported by ZXR10 7800.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 NAT Configuration
Name of the address pool, 1 ~ 16 characters
Starting address of the pool in the dotted
decimal notation
Ending address of the pool in the dotted
decimal notation
Length of the network prefix, ranging 24 ~ 32
Port number, 1~65535
slot number, 1~12
13