Debug Mpls Ldp Messages - Zte ZXR10 Command Manual

ZXR10 Command Manual (Basic Configuration Volume III)
Purpose
Command Modes
Syntax
Syntax
Description
Example
100 Confidential and Proprietary Information of ZTE CORPORATION
ZXR10# debug mpls ldp vpwsfsm
ldp: release label is 16
l2vpn: L2VpwsSentToforwardwith !Local_label:16,
Remote_label:16,
Vpnid:1,vcid:201,tunnelid:0

debug mpls ldp messages

Use this command to monitor the messages sent to or received
from the LDP neighbors. Cancel the monitoring with the no com-
mand.
Privileged EXEC
debug mpls ldp messages {received | sent}
no debug mpls ldp advertisement {received | sent}
received
sent
This example describes how to monitor the messages sent to or
received from the LDP neighbors, including the periodic Keep Alive
messages.
ZXR10#debug mpls ldp messages received
ZXR10#debug mpls ldp messages sent
ldp: Rcvd init msg from 144.0.0.44
ldp: Sent init msg to 144.0.0.44:0
ldp: Sent keepalive msg to 144.0.0.44:0
ldp: Rcvd keepalive msg from 144.0.0.44:0
ldp: Sent address msg to 144.0.0.44:0
ldp: Sent label mapping msg to 144.0.0.44:0
ldp: Rcvd address msg from 144.0.0.44:0
ldp: Rcvd label mapping msg from 144.0.0.44:0
ldp: Rcvd label mapping msg from 144.0.0.44:0
ldp: Rcvd label mapping msg from 144.0.0.44:0
......
The displayed field descriptions are shown below.
Field
Ldp
Rcvd xxx msg Sent
xxx msg
from a.b.c.d
From a.b.c.d:e to
a.b.c.d:e
Monitors the messages received from the LDP
neighbors.
Monitors the messages sent to the LDP
neighbors.
Description
Indicates the debugging information is from
the LDP module
Message type
Messages received from a router, used in
the initial phase of the session establishment
when the LDP ID is unknown
Specifies the destination/source LDP ID