BEAM settings
When "AUTO SETUP" in the "IntelliBeam" menu (p. 33) is used, recommended beam
settings are automatically applied by this unit. However, "HORIZONTAL ANGLE",
"BEAM TRAVEL LENGTH", "FOCAL LENGTH" (except "Center"), and "IMAGE
LOCATION" settings can later be fine-tuned.
Surround sound channel output can also be modified from the "BEAM" menu.
HORIZONTAL ANGLE
➜
SETUP MENU
BEAM
Adjust the horizontal angle of sound beams for each channel using test tones.
Adjust toward L (left) to move the direction of the output to the left and adjust toward R
(right) to move it to the right.
Beam angle
Angle to
left
Item
Front L, Front R, Center. Surround L, Surround R
Control range
L90° to R90°
Left
key:
Increase angle.
key:
Decrease angle.
• Channels that cannot be configured are displayed in grey as settings are specified as indicated in
SETUP MENU
Specify the distance that sound beams travel for each channel. The distance starts at
this unit, ends at the listening position, and includes refraction off a wall. The audio
HORIZONTAL
➜
delay is adjusted and sound from each channel arrives at the listening position
ANGLE
simultaneously.
Item
Front L, Front R, Center, Surround L, Surround R
Control range
0.3 m to 24.0 m (1.0 ft to 80.0 ft)
Angle to
right
• Configure this setting only when you have adjusted "HORIZONTAL ANGLE".
Right
• Channels that cannot be configured are displayed in grey as settings are specified as indicated in
key:
Increase angle.
key:
Decrease angle.
"Switching between audio output methods for surround playback" (p. 42).
BEAM TRAVEL LENGTH
➜
BEAM
The length of each
arrow indicates the
beam travel length.
"Switching between audio output methods for surround playback" (p. 42).
BEAM TRAVEL
➜
LENGTH
SETTINGS ➤ Setup menu
En
53