Number Buttons - Sony CDX-GT572 Operating Instructions Manual

F OPEN button page 5
G ALBM +/– buttons (during MP3/WMA
playback)
To skip albums (press); skip albums
continuously (press and hold).
H Receptor for the card remote
commander
I SEEK –/+ buttons
CD:
To skip tracks (press); skip tracks
continuously (press, then press again within
about 1 second and hold); reverse/fast-
forward a track (press and hold).
Radio:
To tune in stations automatically (press); find
a station manually (press and hold).
J MODE button page 8
To select the radio band (FM/MW/SW)*.
K BTM button page 8
To start the BTM function (press and hold).
L Frequency select switch (located on the
bottom of the unit)
See "Frequency select switch" in the
supplied installation/connections manual.
M Number buttons
CD:
(3): REP page 8
(4): SHUF page 8
(6): PAUSE
To pause playback of a CD on this unit.
To cancel, press again.
Radio:
To receive stored stations (press); store
stations (press and hold).
N DSPL (display)/SCRL (scroll) button
page 8
To change display items (press); scroll the
display item (press and hold).
O RESET button page 4
P Z (eject) button page 5
To eject the disc.
Q Disc slot page 5
To insert the disc.
The following buttons on the card remote
commander have also different buttons/functions
from the unit. Remove the insulation film before
use (page 4).
qk < (.)/, (>) buttons
To control CD/radio, the same as (SEEK)
–/+ on the unit.
Setup, sound setting, etc., can be operated by
< ,.
ql DSPL (display) button
To change display items.
w; VOL (volume) +/– button
To adjust volume.
wa ATT (attenuate) button
To attenuate the sound. To cancel, press
again.
ws SEL (select) button
The same as the select button on the unit.
wd M (+)/m (–) buttons
To control CD, the same as (ALBM) +/– on
the unit.
Setup, sound setting, etc., can be operated by
M m.
wf SCRL (scroll) button
To scroll the display item.
wg Number buttons
To receive stored stations (press); store
stations (press and hold).
* In the case of a CD/MD changer being connected;
when (SOURCE) is pressed, the connected device
("MD") will appear in the display, depending on
which device is connected. Furthermore, if (MODE)
is pressed, you can switch the changer.
Note
If the unit is turned off and the display disappears, it
cannot be operated with the card remote commander
unless (SOURCE) on the unit is pressed, or a disc is
inserted to activate the unit first.
7