Desktop Charger Status
The Charger displays the battery's charge status. The indicator will show one of
the following:
solid red =1-30%; solid yellow =31-60%; flashing green =61-90%; solid green
=91-100%.
Desktop Charger Troubleshooting
If the battery is not charging and there is:
A flashing yellow indicator -
•
If a battery is in the rear pocket, the rear pocket's LED continues to flash
yellow (indicating that the charger's pocket is in a "Wait State") until the
battery in the front pocket is more than 90% charged (front pocket's LED is
solid green). This is normal operation.
•
To protect your battery's life expectancy, the Charger does not rapid charge
a battery when its temperature is below 5
No LED indication -
•
Check that the i700plus with battery, or a battery alone, is inserted
correctly.
•
Make sure that the power supply is plugged into an appropriate AC outlet
and that the connector is properly seated.
•
Rear pocket only: Remove the battery from the Charger. Use an ordinary
pencil eraser to clean the three metal contacts on the battery and then place
the battery in the Charger.
•
If the LED indicator remains turned OFF, the battery may be defective and
should be replaced.
A flashing red indicator -
•
Remove the battery from the Charger. Use an ordinary pencil eraser to
clean the metal contacts on the battery and then place the battery into the
Charger.
•
If the LED indicator continues to flash red, the battery may be defective
and should be replaced.
•
If both LEDs flash red, this indicates that the incorrect power supply is
plugged in.
76
o
o
C (41
F) or above 45
www.nextel.com
o
o
C (113
F).