Servo Reverse; Changing The Neutral Position; Modifying The Throttle Stick To A Ratchet Type - FUTABA Attack 2ER Instruction Manual

This function reverses the rotation direction of the Steer-
ing and Throttle servos.
When the trim position deviates from the center, the
deviation will be on the opposite side when the servo is
reversed.
Change the neutral position only when large forward
stroke of the throttle stick is need when using an FET
E.S.C., etc.
(The neutral position is set to the center at the factory.)
1
Remove the four transmitter rear case screws and
remove the front case.
2
Move the setting lever at the throttle stick body to
the outside.
3
Close the front case while being careful that the
stick levers, trim levers, power switch, LEDs, and
battery contacts do not get caught. And tighten the
four screws.
However, when returning from the 2:1 to the 1:1 posi-
tion (neutral center), return the setting lever to the 1:1
side with the stick lever pushed to the HI side. Other-
wise, the setting lever cannot move.

Modifying the Throttle Stick to a Ratchet Type

Open the transmitter front case and modify the stick
section. (For a description of how to open the case, see the
"Changing The Neutral Position" section.)
*The ratchet plate (sold separately) is
necessary for this modification.
1
Remove the spring and swing
arm.
2
Install the ratchet plate with the
screw.
14

Servo Reverse

Changing the Neutral Position

Throttle
N Side: Normal
R Side: Reverse
Screw
1 : 1 side
Setting Lever
(Throttle Stick)
Swing Arm
Screw
Ratchet Plate
(Sold separately)
Spring
Steering
2 : 1 side