Trouble-Shooting And Maintenance - Pro-Form PFSY64390 User Manual

Trouble-shooting and Maintenance

Inspect and tighten all parts each time you use the home gym. Replace any worn parts immediately. The home
gym can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.
Tightening the Cables
Woven cable, the type of cable used on the home gym,
can stretch slightly when it is first used. If there is slack in
the cables before resistance is felt, the cables should be
tightened.
Slack can be removed from the cables in several different
ways:
The Pulley Plates (23) have several sets of adjustment
holes. By moving one or both pulleys to a different set of
holes, the cables will be tightened.
To move a Pulley, remove the 3/8Ó Nylon Locknut (50)
and the 3/8Ó x 2Ó Bolt (54). Remove the Cable Trap (25)
and the Pulley (24) from the Pulley Plates (23). Re-attach
the Pulley and the Cable Trap to the appropriate hole in
the Pulley Plates. Note: Begin by moving one Pulley to
the second adjustment hole. If the Cables are still too
loose, move the same Pulley to the third hole. If addi-
tional adjustment is needed, move the second Pulley
until the Cables are tight.
The bolt at the end of the Weight Cable (72) is one of the
means for tightening the Cables. Use the following proce-
dure for tightening the Cables: Loosen the 1/2Ó Plain Nut
(107). Thread the bolt at the end of the Weight Cable into
the Weight Tube (17) until all Cables are tight and rest
firmly in the grooves of all Pulleys. Then tighten the 1/2Ó
Plain Nut (107) onto the 1/2Ó Washer (86).
Note: The Shroud is shown removed for clarity. The
Shroud does not need to be removed to tighten the
Cables.
Note: If a Cable tends to slip off the Pulleys often, the
Cable may have become twisted. Remove the Cable
and re-install it.
If the Cables need to be replaced, see ORDERING
REPLACEMENT PARTS on the back cover of this manual
23
54
72
Bolt
107
86
17
26
Adjustment
Holes
50
25
24