Table 2-2. Required Equipment; Table 2-3. Recommended Screw Torques - HP OmniBook 7100 Service Manual

Notes
Reassembly steps are the reverse of the removal steps. Reassembly notes are included at the
end of each section below.
Symbols like this throughout this chapter show approximate full-size screw outlines. You
can use them to verify the sizes of screws before you install them. Installing a wrong-size screw
can damage the unit. (The symbol at the left represents an M2.5×5mm screw.)
•
Small Phillips screwdriver, preferably magnetized.
•
5 mm hex driver.
•
Probe or tweezers.
•
Small flat-blade screwdriver.
•
Needle-nose pliers.
•
IC insertion/removal tool.
Screw Thread Size
M2
M2.5
except those below
M2.5
for display brackets and hinge mounts
M3
2-2 Removal and Replacement

Table 2-2. Required Equipment

Table 2-3. Recommended Screw Torques

Torque (kgf•cm)
1.5 – 2.0
1.5 – 2.5
2.0 – 2.5
4.5
Torque (in•lbf)
1.3 – 1.7
1.3 – 2.2
3.9
1.7 – 2.2
HP OmniBook 7100