HP OmniBook 7100 Service Manual page 61

0182h Make sure that another application is not using
all extended memory allocated by
HIMEM.SYS.
0183h No extended memory. Check installation of
RAM boards. Replace the motherboard.
0190h - For 01FFFFFFh and below, replace the
01A0h motherboard. For 02000000h and above,
replace the corresponding RAM board (each
01000000h represents 16MB).
Hard Disk Tests
0201h Replace the hard disk. Replace the
motherboard.
0202h - Rerun the test. If error persists, replace the
0204h hard disk.
0205h Replace the motherboard.
0207h Run BIOS Setup and check the hard disk type.
Check internal and external hard disk
connectors and motherboard connector.
Replace the hard disk.
0208h - Transient DMA error. Rerun the test.
0209h
020Ah - Rerun the test. Run SCANDISK or equivalent.
0211h
0220h Replace the motherboard.
0240h Replace the hard disk. Replace the
motherboard.
0280h Check internal and external hard disk
connectors and motherboard connector.
Replace the hard disk.
0281h Replace the hard disk.
02AAh Check internal and external hard disk
connectors and motherboard connector.
Replace the hard disk.
02CCh Run BIOS Setup and check the hard disk type.
Replace the hard disk or the motherboard.
02EEh For the performance test, run BIOS Setup and
temporarily select a drive type that has more
than 200 cylinders.
02F1h Recreate the Hibernate partition, then run
FDISK to partition the hard disk.
02F2h Run FDISK to make one partition active. If
necessary, recreate the Hibernate partition,
then run FDISK to partition the hard disk.
02F3h Run FDISK to check for overlapping partitions.
If necessary, recreate the Hibernate partition,
then run FDISK to partition the hard disk.
02F4h Check for the presence of a boot sector virus.
If necessary, recreate the Hibernate partition,
then run FDISK to partition the hard disk.
02F5h Reformat the partition.
02F6h Recreate the Hibernate partition, then run
FDISK to partition the hard disk.
02FFh Check internal and external hard disk
connectors and motherboard connector.
Replace the hard disk. Replace the
motherboard.
Floppy Disk Tests
0301h Replace the floppy drive. Replace the
motherboard.
0302h Run BIOS Setup and check the floppy drive
type. Replace the floppy drive.
0303h Insert a floppy disk without write protection.
3-14 Troubleshooting and Diagnostics
0304h Run BIOS Setup and check the floppy drive
type. Replace the floppy drive.
0305h Replace the motherboard.
0307h Run BIOS Setup and check the floppy drive
type. Check the connectors on the floppy drive
and motherboard. Replace the floppy drive.
0308h - Transient DMA error. Rerun the test.
0309h
030Ah - Rerun the test with a good floppy disk. Replace
0310h the floppy drive.
0311h Rerun the test with another floppy disk.
0321h - Replace the floppy drive.
0322h
0340h Replace the motherboard.
0380h - Make sure the floppy disk is fully inserted.
03AAh Check the connectors on the floppy drive and
motherboard. Replace the floppy drive.
03CCh Run BIOS Setup and check the floppy drive
type. Rerun the test with another floppy disk.
Replace the floppy drive. Replace the
motherboard.
03EEh - Check the connectors on the floppy drive and
03FFh motherboard. Rerun the test with another
floppy disk. Replace the floppy drive. Replace
the motherboard.
Keyboard Tests
0400h - Replace the motherboard.
0401h
0410h - Check the keyboard flex cable connection.
0414h Replace the keyboard. Replace the
motherboard.
0415h Check icon PCA connections. Replace the icon
PCA. Replace the motherboard.
0416h - Replace the keyboard. Replace the
0418h motherboard.
Serial Port Tests
0601h For the external loopback test, make sure the
loopback connector is installed and constructed
properly. For the external or internal loopback
test, replace the motherboard.
0602h Replace the motherboard.
0603h For the external loopback test, make sure the
loopback connector is installed and constructed
properly. For the external or internal loopback
test, replace the motherboard.
0604h - Replace the motherboard.
0605h
0606h For the external loopback test, make sure the
loopback connector is installed and constructed
properly. For the external or internal loopback
test, replace the motherboard.
0607h Make sure the loopback connector is installed
and constructed properly. Replace the
motherboard.
0608h - Replace the motherboard.
0611h
Parallel Port Tests
0701h For the external loopback test, make sure the
loopback connector is installed and constructed
properly. For the external or internal loopback
test, replace the motherboard.
0702h Replace the motherboard.
HP OmniBook 7100