Resetting & Factory Settings - La Crosse Technology WS-2306 Operation Manual

10. Resetting & factory settings
As previously mentioned, in the event of a power reset to the sensor
(for example a change of batteries), the base station has to
synchronize to the sensor again otherwise no weather data will be
received. To do this, simply press and hold the PLUS (+) key for 2
seconds and a short beep will sound to synchronize the base station
to the sensor. When the units are synchronized, the data will be
received again and the base station will return to normal operation
mode.
Do not remove batteries or unplug the AC adaptor of the base station
otherwise all 175 sets of recorded weather history data for
transferring to the PC will be lost (for full details of PC use, please see
PC user manual in the enclosed Heavy Weather CD-ROM).
Factory Reset: However if you wish to make a full reset of the base
station and return to the original factory settings, simultaneously press
and hold the PRESSURE and WIND keys for about 10 seconds. The
base station will beep once and the entire LCD will light up for 5
seconds and go back to the original factory settings. This process will
clear all previous user defined values and all weather history
recordings.
Factory default settings:
The following table shows the factory default values of the weather
station:
Matter:
Time
Date
Time zone
Alarm time
Relative air pressure
Weather-picture threshold
LCD contrast level
Rainfall per impulse
Storm alarm
Relative air pressure
alarm
Indoor temperature alarm
Outdoor temperature
alarm
Indoor humidity alarm
Outdoor humidity alarm
Wind chill alarm
Default Setting:
0:00
01.01.2001
0
0:00
1013.0 hPa
3 hPa
5 (1-8 levels)
0.518mm
5 hPa
960.0 hPa 1040.0 hPa
(low) (high)
10.0°C (low) 30.0ºC (high)
0.0ºC (low) 40.0ºC (high)
35%RH (low) 65%RH (high)
45%RH (low) 70%RH (high)
10.0ºC (low) 30.0ºC (high)
18