La Crosse Technology WS-2306 Operation Manual page 16

Once the wind sensor is fixed onto the mast, connect the cable to the
corresponding thermo-hygro sensor socket so that operating power
supply can be received and data can be transmitted to the base
station. Be sure to leave a small amount of cord below the thermo-
hygro sensor as a "drip loop" to prevent water from running into the
ports of the sensor.
It is NOT RECOMMENDED to mount the sensors with the nylon
straps as they may stretch in extreme weather. Straps are excellent to
secure wind and rain cords from blowing about.
1. Unlock the mounting bracket from the remote wind speed sensor
leaving the wire going through the bracket.
2. Place two nylon straps through the slots on the mounting bracket.
3. Place the remote wind speed sensor in your desired location.
4. Fasten the two nylon straps securely around the mounting
location.
5. Slide the remote wind speed sensor onto the bracket making
sure to lock it in place.
Mounting the Rain Sensor
Funnel portion
Base portion
Wind
vane
Fixed with
screw
Horizontal panel
15