Panasonic Lumix DMC-LZ30P Service Manual page 25

Lumix digital camera

Table of Contents

8.3.5.

OB Calibration

1. Setting the DSC

1. Set the battery to the camera.

2. Turn off the power.

3. Press "Tele" + "Menu/Set" + "Playback" key at the same time. It starts in the state of "Engineer Mode" automatically.

4. Press "Playback" key to enter selection menu.

5. Put the DSC on a desk where the lens side is turned downward in order to make "all black" environment.

2. Execute Calibration

1. Press "Right Key" or "Left Key" or "Up Key" or "Down Key" to change selected item.

2. Choose "OB CLB(BLACK)", and press "Display Key".

3. Change the flag status of "Disable" from 00001 to 00000 by operating "Right Key" or "Left Key", and then press "Menu/Set

Key".

4. Press "Menu/Set Key" again, and select "OK", and press "Menu/Set Key" to start checking.

5. When calibration finishes, the screen will show the result "OK" or "NG".

6. Press "PLAYBACK Key" to return to calibration menu.

8.3.6.

WB/AGC Calibration

1. Setting the DSC

1. Set the battery to the camera.

2. Turn off the power.

3. Press "Tele" + "Menu/Set" + "Playback" key at the same time. It starts in the state of "Engineer Mode" automatically.

4. Press "Playback" key to enter selection menu.

5. To Select the Light box mode, carry out the following operations.

a. Press "Right Key" or "Left Key" to change selected item to "WB/AG(LV10)", and press "PLAYBACK Key".

b. Press "UP Key" or "Down Key" to change selected item to "Light Src", and press "Right Key" or "Left Key" to set the value

as "00002", and press "MENU/SET Key".

6. Set the DSC to the front of light box closely.