Bosch 24618 Operating/Safety Instructions Manual page 17

BM 2610027761 08-12_BM 2610027761 08-12.qxp 8/17/12 1:54 PM Page 17
Cleaning
To avoid accidents, always
WARNING
disconnect the tool and/or
charger from the power supply before
cleaning. The tool may be cleaned most
effectively with compressed dry air. Always
wear safety goggles when cleaning tools
with compressed air.
If an extension cord is
WARNING
necessary, a cord with
adequate size conductors that is capable of
carrying the current necessary for your tool
must be used. This will prevent excessive
voltage drop, loss of power or overheating.
Grounded tools must use 3-wire extension
cords that have 3-prong plugs and receptacles.
NOTE: The smaller the gauge number, the
heavier the cord.
RECOMMENDED SIZES OF ExTENSION CORDS
(* = standard equipment)
(** = optional accessories)
Ventilation openings and switch levers must
be kept clean and free of foreign matter. Do
not attempt to clean by inserting pointed
objects through opening.
CAUTION
plastic parts. Some of these are: gasoline,
carbon tetrachloride, chlorinated cleaning
solvents, ammonia and household detergents
that contain ammonia.
Accessories
120 VOLT ALTERNATING CURRENT TOOLS
Cord Size in A.W.G.
Tool's
Ampere
Cord Length in Feet
Rating
25
3-6 18
6-8
18
8-10 18
10-12 16
12-16
14
* Screwdriver bit
* Carrying case
-17-
DV-2610027761, Page: MUL (VAA), downloaded at: 2014.04.09_19:12:09, by PT-BNA/MKP1_Tom.Jaroszek
Certain cleaning agents
and solvents damage
2
Wire Sizes in mm
Cord Length in Meters
50 100 150 15 30 60 120
16 16 14 0.75 0.75 1.5 2.5
16 14 12 0.75 1.0 2.5 4.0
16 14 12 0.75 1.0 2.5 4.0
16 14 12 1.0 2.5 4.0 —
12 — — — — — —