JVC GY-DV300 Instruction Manual page 23

Normal display in the shooting mode
No. Item
1
Zoom ratio (Characters, Displayed during zoom operation. The characters indicate the wide-
numeric value)
2
Time code display
3
Recording time mode
indication
4
Remaining tape time
indication
5
Remaining battery
power indication
q
angle (W) and telephoto (T) zoom positions. The numeric value indicates
the approximate zoom ratio.
Shows the time code (hours, minutes, seconds, frames).
Whether this should be displayed can be selected by setting the TIME
CODE item on the DISPLAY [2/2] menu screen.
Shows the recording speed at the time of the recording.
SP : Standard Play mode
LP : Long Play mode
When the remaining tape indication is OFF, this indication is shown at
the 4 position.
Indicates the remaining tape amount (minutes) in 1-minute steps.
Whether this indication should be ON or OFF can be selected by setting
the TAPE REMAIN item on the DISPLAY [2/2] menu screen.
* The indication may not appear when a new tape is loaded, after the
tape runs, the indication appears.
* When used in a cold environment, it may take a little while before the
remaining tape time indication appears.
The remaining battery power is indicated by four different indicators.
Fully charged
battery
w
Contents
Blinking indicator
(no remaining
battery power)
e
r
t
E-23