Citizen CBM1000 Service Manual page 11

(8) Installing Top Cover SA
• Connect operation panel connector.
Pass operation panel connector under cable
holder.
• Cover with top cover SA directly over top of
mechanism unit
Fit power switch in the power switch cutout
in top cover SA.
• Lower the top cover SA as shown in the
diagram.
Press it down from above until it clicks into
place.
• Secure top cover SA to mechanism unit with
two screws (M3 × 6 (ST)).
(9) Installing Printer Cover SA
• Hitch the two rear corners 1.
• Hitch the two sections 2 and press in
direction of arrow.
• Secure with two screws (M3 × 8 (BT)).
Square hole
Power switch
7
CBM1000 TYPE II Service Manual
Top cover SA
M3 × 6 (ST)
Operation panel
connector
Cable holder
Printer cover SA
M3 × 8 (BT)