Table of Contents
Advertisement
I.
Slide top weight onto guide rods.
J.
Place lower snap ring and wave washer onto guide
rod (about 3" from the top end of guide rod).
K.
Raise guide rod up through mounting hole and install
the upper snap ring.
L.
Lower guide rod and secure lower snap ring. Repeat
steps 6J - 6L for the other guide rod.
7. Belt Routing.
A.
Verify belt is routed through top of pulley bracket
and then route end of belt down to the top weight.
B.
Carefully lift top weight and verify that the position of
the belt clamp (on the top weight) is aligned properly
with the top pulley bracket (on the machine). See
Figure 10.
C.
Slide belt through slot in belt clamp.
D.
Verify belt and insert are installed properly, as shown in
Figure 11A. NOTE: Do not install the insert backwards
as shown in Figure 11B.
E.
Pull belt tight and secure belt to clamp with the two set
screws. NOTE: Torque set screws 300-350 in./lbs.
See Figure 12.
F.
Place weight stack pin in each plate to verify proper installation.
G.
Without selecting any resistance, lift top weight up and
down (simulating normal operation).
H.
Have an assistant verify that the belt is moving smoothly
and is routed straight from the top pulley bracket to the
to weight belt clamp.
I.
Reinstall the six increment weights that were removed
in step 6B. See Figure 13.
J.
Turn the Increment Weight Adjusting Knob to select
all 15 lbs.
8. Install back shrouds.
A.
Carefully place shroud back into position on the two
bottom screws. See Figure 14.
Assembly
Page 4-4
Cybex Eagle 11040 Leg Press Owner's Manual
Insert and Set Screws (not
shown) are on this side.
Belt
Increment
Weight
Adjusting
Knob
Figure 10 (top view from pulley down to belt clamp)
Correct belt routing
Insert
Belt
Stem
Figure 11A
Belt
Set screws
Figure 12
Grooves
Increment Weights
Figure 13
Figure 14
Top Pulley
Wrong belt routing
Insert
Stem
Figure 11B
Belt clamp
insert
Belt clamp
Screw
Belt
Advertisement
Table of Contents
