Connecting Using The Pc Cable - Panasonic KX-NT700 Operating Instructions Manual

Using a Portable Station (PS) or Computer

Connecting Using the PC Cable

Connecting to a Computer
Connect the included PC Cable to the [AUDIO IN/
OUT] jack of the unit (A), and to the microphone jack
(red plug; B) and headphone jack (green plug; C) of
the computer.
A
Note
•
The microphone and speaker of the computer
cannot be used while the computer is
connected to the unit.
Line Selection (IP + PC)
1.
Press [MENU].
2.
Press .
LINE
•
When the operation mode is set to "USB
Audio",
LINE
select a line type.
3.
Select "IP + PC".
•
When "Line Selection" is set to "IP +
PC", TEL calls cannot be made or received.
4.
Press .
SAVE
5.
Press [MENU].
46 Operating Instructions
B
C
is not displayed and you cannot
Using a Computer
1.
Confirm that "PC" is shown in the upper-right corner
of the display.
•
You can change the selected line by pressing
the centre function button ([F2]).
The IP line is selected.
[F2]
•
If you cannot select "PC", change the "Line
Selection" setting to "IP + PC" (explained
on this page).
2.
Press [ ] to begin using the unit's microphones
and speaker.
•
Press [ ] again to turn off the microphones
and speaker.
3.
Use the desired computer software to make or
answer a call.
4.
Use the computer to end the call.
5.
Turn off the unit's microphones and speaker by
pressing [ ].
Note
•
Leave at least 50 cm of space between the unit
and the computer.
The PC line is selected.
[F2]
Document Version 2010/02