Warnings - Capital MCR304 Use And Care & Installation Manual

WARNING! If the information in this manual is not
followed exactly, a fire or explosion may result
causing property damage, personal injury or death.

WHAT TO DO IF YOU SMELL GAS

Do not try to light any appliance

Do not touch any electrical switch

Do not use any phone in your building

Immediately call your gas supplier from a neighbors
phone. Follow the gas supplier's instructions.

If you can not reach your gas supplier, call the Fire
Department
Installation and service must be performed by a qualified
installer, service agency or the gas supplier.
The appliance and its individual shutoff valve must be dis-
connected from the gas supply piping system during any
pressure testing of that system test pressures in excess of 5
psi (35 kpa).
The appliance must be isolated from the gas supply piping sys-
tem by closing its individual manual shutoff valve during
any pressure testing of the gas supply piping system at test
pressures equal or less than 5 psi (35 kpa).
WARNING! Disconnect Power before installing.
Before turning power ON, be sure that all
controls are in the OFF position.
IMPORTANT! Installation must conform with local
codes or, in the absence of local codes, with the
National fuel Gas Code, ANSI Z223.1/NFPA54.

Smother flames with a close fitting lid, or any metal
tray.

Turn OFF the burner. Be careful to prevent burns. If the
flames do not extinguish, immediately evacuate and
call the Fire Department

NEVER pick up a flaming pan. By doing so, you may
be seriously injury.

WARNINGS!


DO NOT use water or a wet dishcloth on fire. A violent
steam explosion will result. Use a fire extinguisher
only if:

You have CLASS ABC extinguisher and you know
how to operate it.

The fire is small and contained in the area where it
started.

The Fire Department has been called.

You can fight the fire with your back to the exit.
FOR YOUR SAFETY! If You Smell Gas:
Shut off gas to the appliance. Extinguish any open
flames. If odor persists, immediately call your gas sup-
plier.
This appliance is designed for easy installation and
operation. However, we recommend that you read all
sections of this manual before installation and that your
range is installed by an approved gas installation techni-
cian capable of reviewing and performing the manufacturers
installation checklist included in your information packet.
The installation of appliances assigned for manufactured
(mobile) home installation must conform with the Manufactured
Home Construction and Safety and Safety Standard, Title 24
CFR, Part 3280 or, when such standard is not applicable
Standard for Manufactured Home Installations, ANSI/
NCSBCS A225.1, or with local codes as applicable.
The installation of appliances designed for
Recreation Park Trailers must conform with
State or other codes or, in the absence of such
codes, with the standard for Recreational Park
Trailers, ANSI A119.5.
The appliance, when installed, must be electri-
cally grounded in accordance with local codes
or, in the absence of local codes, with the
National Electrical Code, ANSI/NFPA 70
MCR-SERIES
WARNING! If the information in this manual is not
followed exactly, a fire or explosion may result,
causing property damage, personal injury or death.
Please read the installation, operating and mainte-
nance instructions thoroughly before use.
CAUTION! When connecting the unit to propane
gas, make certain the propane tank is equipped
with its own high-pressure regulator in addition to
the pressure regulator supplied with the range.
The pressure of the gas supplied to the appliance
must not exceed 14" (34.57 mB) water column
from the propane gas tank to the pressure regu-
lator.
CAUTION! Do not store or use gasoline or any
other flammable liquids in the vicinity of this or any
other appliance.
PLEASE RETAIN
MANUAL FOR FUTURE
REFERENCE!
PLEASE NOTE:
In the Commonwealth of Massachusetts, gas
connection must be performed by a licensed
plumber or licensed gas fitter.
IMPORTANT!: For fire safety and correct operation,
a combustible back wall surface must install the
provided rear trim or meet the clearances for
combustible back wall construction as described in
the Installation Instruction section of this manual.
Rear wall construction of Non-Combustible
materials do not require the installation of the rear
trim.
THIS
8