Haier AB242ACBEA Service Manual page 36

(2) Remove cover plate at corner
Tear off the adhesive tape,
and slide it off.
(Refer to Fig. 3)
2. Install ornament panel on indoor unit.
For indoor unit installation, please refer to Installation Manual.
(1) As shown in Fig . 7, match the position of
swing flap motor with that of the indoor unit
piping hole , so that ormament panel can be
placed on to indoor unit.
(2) Installation of ornament panel
1 Place the holding ring on swing flao motor
side teporarily on hooks of the indoor unit.
(2 pcs)
Put the other two holding rings on the hooks at
2
both side of the indoor unit. (Care should be
taken not to push wiring of swing flap motor
into seals).
Screw in all 4 screws under holding ring for
3
about 15mm. (Pancl will rise).
Adjust the ornament panel as per Fig. 7 to
4
cover opening on the ceiling.
Tighten screws to redrce the thickness of seals
5
between ornament and indoor unit to 5-
8mm.
If screws are not tighten tight, problems in Fig, 8
might occur. Tighten screws properly.
Gas leakage.
Gas leakage from roof.
Contamination
Mist exists and drop down.
Fig. 8
3. Mounting on high ceiling
(1) Ornament panel can be mounted on ceiling as high as 3 m.
(2) Please install pad as accessary.
Cut open the pad along cutting ling. Use part a only and discard part b . (Refer to Fig. 4)
1
Install part a of the pad on the place shown in Fig. 5. Refer to Fig. 6.
2
Cutting line
a
50
100
Fig. 4
(3)Wiring on ornament panel
Connecting of wiring of the swing
flap motor on ornament panel. (2 places)
(Refer to Fit . 10)
If connecting is not made, error code
(A7) appears on remote controller. So,
make proper connecting.
Caution
If there are still space after tightening
of screws, please readjust the height
of indoor unit. (Refer to Fig. 9)
Leave no space.
b
Part a of the pad
Swing flap motor
INSTALLATION INSTRUCTIONS
Slide
Fig. 3
Holding ring
2
Piping hole position
Swing flap motor
3
4
Fig. 7
Indoor unit
Ceiling material
If indoor unit is at horizontal level
and water drainage is smooth,
then, indoor unit height can be ad-
justed throrgh holes at corners of
ornament panel.
Fig. 9
Place it on the frame.
Part a of the pad
Fig. 5
Side of indoor unit
Adhesive tape
45
Fig. 2
Hook
1
2
Seal
5 _ 8mm
Ornament panel
Leave no space.
Fig. 6
Side of ornament panel
Fig. 10
Wiring diagram