How To Run A Wash Cycle; Daily Use - Electrolux EWB 105405 W User Manual

To activate child safety, turn appliance on
and press "Extra rinse"
simultaneously until the confirmation
symbol shows on in the display. The ap-
pliance memorises the selection of this op-
tion. To deactivate child safety, repeat the
process.
AUDIBLE SIGNAL
When the audible signal is activated, it
sounds when a button is pressed, at the
end of the programme, to indicate a fault.

HOW TO RUN A WASH CYCLE?

USING FOR THE FIRST TIME
• Ensure the electrical and water con-
nections comply with the installation
instructions.
• Remove the polystyrene insert and
all other items inside the drum.

DAILY USE

LOADING WASHING
• Open the lid of
the appliance.
• Open the drum
by depressing
the locking but-
ton A: The two
shutters unlock
automatically.
• Load the wash-
ing, close the
drum and the lid of your washing ma-
chine.
Warning! Before closing the lid of your
appliance, ensure that the drum is
properly closed :
• When the two shutters are closed,
• locking button A released.
PROPORTIONING OF DETERGENTS
Pour the amount of washing into the wash-
ing and prewash
you have selected the "prewash" option.
Pour fabric softener into the compartment
if necessary.
and "Delay start"
A
compartments if
To deactivate, turn appliance on and press
"Prewash" and "Extra rinse"
neously until the beep sounds. The signal is
only active if alarm sounds. To reactivate it,
repeat the same process.
• Run an initial wash cycle at 90°C,
without any washing but with deter-
gent to clean the water tank.
SELECTION OF DESIRED
PROGRAMME
Turn the programme selector to the re-
quired programme. The "Start/Pause"
pushbutton flashes green.
If you turn the programme selector to an-
other programme while a cycle is in pro-
gress, the appliance will ignore the new se-
lected programme. "Err" flashes and the
"Start/Pause" pushbutton flashes red for
a few seconds.
SELECTING THE TEMPERATURE
Press the "Temperature"
peatedly to increase or decrease the tem-
perature (see "Programmes table"). The
symbol means a cold wash.
SELECTING THE SPIN SPEED
Press the spin button
speed. You can also select "Rinse hold"
or "Night cycle"
For the maximum spin speeds see "Wash-
ing programmes".
Rinse hold
By selecting this function the water of the
last rinse is not emptied out to prevent the
fabrics from creasing.
electrolux 5
simulta-
pushbutton re-
to change the spin
.