Electrolux EWB 105405 W User Manual page 12

12 electrolux
malfunctions. The appliance can also be
damaged through physical contact.
UNPACKING
1
2
1
2
UNTYING
A B
C
D
B
2
1
Keep the transit
bolts for when you
move the appli-
ance.
1
2
WATER SUPPLY
In case of necessity
move the inlet hose
in the direction
shown on picture.
To make this loose
the inlet hose ring
nut and position the
A
inlet hose down-
wards as drawn on
picture. Tighten the
ring nut back and
make sure there are
no leaks.
DRAINAGE
Fit the U-piece on
1 B
the drainage hose.
Place everything in a
drainage point (or in
a sink) at a height of
2 between 70 and 100
cm. Ensure it is posi-
tioned securely. Air
must be able to en-
ter the end of the
D hose, to avoid any risk of siphoning.
The drain hose must never be stretched. If
it is too short, contact an engineer.
ELECTRICAL CONNECTION
This washing machine must only be con-
nected in single-phased 230 V. Check the
fuse size: 10 A for 230 V. The appliance
must not be connected with an extension
lead or multi-plug adaptor. Ensure that the
plug is earthed and that it is in accordance
with current regulations.
To install the appli-
ance at the same
level as neighboring
furniture, cut these
plastic pieces.
90 90 90
O O O
Open the water inlet
tap. Check there
are no leaks. The
water inlet hose can
not be extended. If
it is too short,
please contact the
after-sales service.
min
max
70 cm
100 cm