Adjusting The Label Taken Sensor - Intermec PF8d User Manual

Chapter 3 — Troubleshooting and Maintaining the Printer

Adjusting the Label Taken Sensor

28
• Turn the adjustment screw counterclockwise or clockwise to
adjust the contact between the printhead and platen roller.
PF
PF8t Printhead Alignment Adjustment Screw
The built-in label taken sensor can be enabled to pause printing until
a printed label is removed from the printer's output slot. The printer
will not continue printing until the label taken sensor no longer
detects a label.
When you are using the ESim protocol, note the following:
• The label taken sensor must be enabled using the manual switch
next to the sensor before it can be enabled or disabled using ESim
commands.
When switching between peel-off, tear-off, and cut-off operation,
•
you must adjust the media feed in ESim by using a j command.
For more information, see the ESim for the PC4 and PF8 Printer
Programmer's Reference Manual (P/N 937-011-xxx).
If you are using InterDriver you can select one of the following modes
of operation without issuing commands:
• Tear-off
Peel-off with label taken sensor enabled
•
Adjustment
screw
PF8d/PF8t Printer User's Guide