Basic Work Technique - Jonsered HT2122T Owner's Manual

2. Avoid usage in unfavourable weather conditions. For
example, thick fog, heavy rain, strong winds or extreme
cold, etc. To work in bad weather conditions is tiring and
can create dangerous circumstances, e.g. slippery surface.
3. Make sure you can walk
and stand safely Look
out for any obstacles
with unexpected
movement (roots,
stones, branches, pits,
ditches, etc.). Take great
care when working on
slopin ground.
4. When moving over longer distances and transporting the
transport guard should be used.
5. Never put the machine down with the engine running
unless you have good sight of it.
6. Never allow children to use the machine.
Safety instructions
Basic working technique
• Always cut with the engine at full throttle.
• Let the engine idle after each work phase. Full revs without
loading the engine can seriously damage the engine.
• Observe great caution when working close to power lines
and wire fencing.
When trimming the top of a
hedge the clippers should be
held so that the blade is at
an angle of between 15° and
30° to the horizontal plane.
Swing the clippers in an arch
over the hedge so that cut
branches are swept off.
To ensure a good working
position for the hand when
trimming hedge sides the
rear grip can be turned on
mod. HT 2122 T and HT
2126 T.
Release the nut (A) and turn
the handle 90° in either
direction.
NOTE!
Remember to tighten
the nut well after
making the adjustment.
When trimming the sides of
the hedge hold the blade
vertically and swing the
clippers in an arch.
15–30°
A
9
English –