Replacement Of Starter Cord And/Or Return Spring; Silencer - Jonsered HT2122T Owner's Manual

WARNING!
• The return spring is tensioned in the
starter housing and can with negligent
handling spring out and cause injury.
• Observe care when replacing the starter
spring or starter line. Use protective
glasses.
Replacement of
starter cord and/
or return spring
1. Remove the 4 screws
which hold the starter
device, and lift off.
2. Make sure that the
return spring is
untensioned and
dismantle the screw
which holds the pulley.
Lift off the pulley.
3. Remove the defective
return spring replace
with a new one.
WARNING!
The spring can with negligent handling
spring out and cause injury. Use
protective glasses.
Maintenance
Lubricate the spring with
thin motor oil.
1. Insert a new starter cord
through the hole in the
starter and anchor it in
the pulley and starter
handle with a knot.
2. Wind 4 turns on line on
the pulley anti-clockwise.
3. Place the pulley over the
journal and make sure
that the return spring
grips in the pulley. Fit
the centre screw with the
accompanying washer.
4. Lift up the cord in the
recess on the pulley and
turn the wheel about 3
turns anti-clockwise to
tension the return spring.
5. Check that the pulley
can be turned an
additional 1/2 turn when
the starter cord is fully
withdrawn.
6. Fit the starter by first
pulling out the starter
cord a little and then
placing the starter in
position against the
crankcase. Now release
the starter cord slowly so
that the start hooks grip
in the pulley.
7. Tighten the screws which
hold the starter.

Silencer

The silencer is designed to
dampen the noise level and
to direct the exhaust fumes
away from the user. The
exhaust fumes are hot and
can contain sparks, which
can result in fire if the
exhaust fumes are directed
towards a dry or
inflammable material.
NOTE!
Never use a machine with a
defective silencer.
4 r
3 r
3 r
15
English –