Specifications - Generac Power Systems 005411-0 Owner's Manual

General Information
2. 120/240 VAC loads — one load with a maximum total watt-
age requirement equal to the generator's rated power output,
and 240V across the generator output terminals; or two sepa-
rate loads, each with a maximum total wattage requirement
equal to half of the generator's rated power output (in watts),
and 120V across the generator output terminals. Figure 1.2,
shows the generator lead wire connections for 120/240 VAC
loads. Also refer to the "Line Breakers" section for circuit
breaker ratings.
This procedure should be done by an Authorized Service Dealer or
other qualified installer.
Figure 1.2 - Connection for 120/240 Volts
GROUNDED NEUTRAL
STATOR POWER
WINDINGS
1.6

SPECIFICATIONS

1.6.1 FUEL REQUIREMENTS (GASOLINE)
This generator is equipped with a gasoline fuel system as standard
equipment. Specific installations may provide either a separate fuel
tank for the generator, or the generator may "share" the vehicle
engine's fuel tank.
1.6.1.1 Fuel Consumption (gph)
Model 10% Load
RV45G .33
RV55G .35
RV65G .37
6
T1
RED
CB1
T2
WHITE
CB2
T3
BLACK
50% Load 100% Load
.45 .73
.55 .89
.65 .97
Some installations using a "shared" fuel tank may have a gen-
erator fuel pickup tube that is shorter than the vehicle engine's
pickup tube. Such an arrangement causes the generator engine
to "run out of gas" while adequate fuel for the vehicle remains
in the tank.
To reduce lead and carbon deposits use high quality UNLEADED
gasoline with the generator. Leaded REGULAR grade gasoline is an
acceptable substitute.
Using unleaded gasoline contributes to longer engine valve life by
reducing lead and carbon deposits.
The manufacturer does not recommend
using any gasoline containing alcohol (such
as "gasohol"). If using any gasoline contain-
ing alcohol, it must not contain more than
10 percent ethanol (Do not use E85), and it
must be removed from the generator during
storage. Do NOT use any gasoline contain-
ing methanol. If using gasoline with alcohol,
inspect more frequently for fuel leaks and
other abnormalities.
1.6.2 ENGINE OIL REQUIREMENTS
All oil should meet minimum American Petroleum Institute (API)
Service Class SJ, SL or better. Use no special additives. Select the
oil's viscosity grade according to the expected operating tempera-
ture (also see chart).
• SAE 30 Above 32° F
• 10W-30 Between 40° F and -10° F
• Synthetic 5W-30 10° F and below
10 W- 3 0 10 W-30
Synthetic 5W-30 Synt he t ic 5 W-3 0
Crankcase and oil filter capacity is approximately 1.4 L or 1.5 U.S.
quarts. DO NOT use special additives. See sections "Checking the
Engine Oil Level" and "Changing the Engine Oil and/or Oil Filter" for
oil level check and filling procedures.
NOTE
NOTE:
SA E 30 SA E 30